CRL
CRL
CRL Polished Stainless Heavy-Duty Single-Arm Spider Fitting for Glass
Item# FMH1PS
Shipping Weight: 1.18 Pounds
Shipping Limitations: None
Minimum Order Quantity: 1
Unit of Measure: each
Compliance and Restrictions
Warning: Reproductive Harm
www.p65warnings.ca.gov
Shipping Weight: 1.18 Pounds
Shipping Limitations: None
Minimum Order Quantity: 1
Unit of Measure: each
Compliance and Restrictions
Warning: Reproductive Harm
www.p65warnings.ca.gov
Buy More, Save More!
| Product QTY | Discount |
|---|---|
| Buy 3 | 2% Off |
| Buy 5 | 4% Off |
| Buy 10 | 6% Off |
| Buy 15 | 8% Off |
| Buy 20 | 10% Off |
- Compatible with monolithic tempered glass up to 1-1/16" (27 mm)
- Mounts a single glass panel to a wall or structural fin
- Includes hardware: two M10-1.5 x 65 mm (2-9/16") stainless steel threaded studs, four cap nuts and washers
- Glass attachments sold separately
This CRL Fitting (SKU: FMH1PS) secures a single glass panel to a wall or structural fin. Supplied with two M10 stainless steel studs and matching cap nuts/washers. Replacement stud set available.
For a companion fitting use Cat. No. FMH2BS or FMH2PS.
Most shipping weights are approximate and have not been verified. If the exact weight is needed to determine shipping costs prior to ordering, contact CRL Customer Service. Product images are actual or close representations; colors may vary with monitor settings.
Stainless Steel Advisory:
Although stainless steel is corrosion resistant, it is not completely rust- or stain-proof. CRL recommends periodic maintenance to preserve the factory finish. See the Stainless Steel Disclaimer in Technical References for details.
Need this fitting for a glass railing or partition project? Order FMH1PS or contact CRL for a replacement stud set and installation guidance.
Cleaning & Maintenance
