Product Details
- Protects Finished Opening by Preventing 'Over Travel' of Door Panel
- Simple to Install
These Door Stops prevent 'over travel' of the door panels used in Laguna Series Assemblies, which helps protect the finished opening and the glass. Door Stops are installed by simply sliding them over the end of the Cat. No. LS104BS Top Sliding Tube and then tightening them in place.
NOTE: Left or right handing is determined as viewed from the hardware side of the opening.
Product Warning:
STRUCTURAL DISCLAIMER - All customers who in any way utilize this product are solely responsible to consult a structural engineer to determine the suitability of the product for the intended use and site conditions. All installers must be qualified and have professional knowledge about compliance with local, state and federal regulations, safety factors, and the appropriate choice of fixing material and procedures.
Stainless Steel Advisory:
Although Stainless Steel is resistant to corrosion, it is not rust or stain proof. CRL recommends periodic maintenance to help maintain its factory finish. For more information, view the Stainless Steel Disclaimer found in the Technical References section below.
